• Dry drilling in pre-cast concrete, concrete, and reinforced concrete (reinforcing bars below 1/2" dia.).
• The carbide center pin ensures accurate hole starting without bit walk.
• Peripheral threading on cutter for efficient removal of dust.
• Heat treated for durability.
• SDS Plus shank.

Applications:

• All kinds of piping work for water, gas, electricity, air-conditioning and drainage jobs.
• Drilling in Hume pipes, ceramic pipes, and PVC pipes.

Specs:

• Diameter: 1 inch to 8-1/8 inches.
• Maximum drilling depth: 6 inches.
• Use only with rotary mode.

• Safer against re-bar.
• Improved drilling speed.
• Low impact, worker friendly.
• Drills near-perfect round holes.
• Easy centering.
• Minimum wear on outside diameter.
• Penetrates through deck-plate.
• For drilling in concrete, block, brick, rock, deck-plate and concrete.
• For use with Rotary Hammer Drill with SDS-max and spline.

NO MORE STICKING!  NO MORE RUBBING!  NO MORE JAMMING!  NO MORE SCRATCHED PAINT!

The Hinge Tweakers are therapy for your doors. To be more precise, the Standard Weight Hinge (RED) is designed to rebend standard weight .134 gauge hinges which are commonly found in interior doors. The Heavy Weight Hinge Tweaker (BLUE) is designed to rebend heavy weight .180 gauge hinges, commonly found on exterior doors. Both of these Hinge Tweakers will help you enable the door to operate correctly. In the door and hardware industry we would effectively call this rebending technique, "closing the swedging of a hinge" or "closing the gap." the Green Dual Standard/Heavy Weight Hinge Tweaker has both Standard Weight and Heavy Weight capabilities on opposite ends of the tool. 

Plugged up grease fittings and bearings are common problems in machinery. Often times, grease dries out before the machine is used again or the grease collects dirt and dust and plugs up the fitting. DCT's Grease Buster busts the grease out of the bearings with a tap of a hammer. The Grease Buster is made of a heavy-duty adjustable hydraulic coupler, cylinder and a piston with a knob. You remove the piston, fill the cylinder with penetrating oil, start the piston back in the cylinder, place the tool onto the grease fitting and by trapping the piston, force the solvent into the fitting and/or bearing.

Used On:

• Back Hoes, Dump Trucks, Front End Loaders, Bobcats, Vehicle Front end Suspension, Drive Shafts.

Used By:

• Conveyor Systems, Machinery, Construction, Distribution Centers, Manufacturing.